UPDATE:
Got bored this afternoon, so decided to assemble the 2-stroke project engine into a usable whippa-snippa again.
As obtained, it had no shaft or cutter head, it was a bare motor only. But I had acquired an identical one with a
seized motor, so I put the good shaft/cutter onto the good project motor. And, bugger me, it went!
Due to the difficulty of holding it down, it wasn't actually started at the course, but the instructor did check it and
gave me a 'pass', so I was fairly optimistic that it would go. I didn't think it would start this easily though.
The only 'teething trouble' was a leaky fuel-line, which was easily fixed.
It is now for sale, I don't need it myself as I have one already. Should bring me a bit of much-needed Xmas pocket-
money, with a bit of luck.